"connect [noreply] unit setname {new_name}" - set unit name

"connect [noreply] unit setsmspassword {new_password}" - set unit password

"connect [noreply] unit setfencesmstel {new_telephone}" - set telephone number where fence breach SMS messages are sent


"connect pos" - request current unit position (lat/long)

"connect position" - request current unit position (lat/long)

"connect fence viewnamelist" - view list of current fence names set

"connect fence view {name}" - requiest full details for specified fence name, ie lat/long/radius/(in/out) type

"connect [noreply] [write] fence set {name} {0000.0000[N|S]} {00000.0000[E|W]} {10.000} {[in|out]}" - set a new fence, radius is specified in miles with upto 3dp.  In/out indicates if the alert should be send if the fence area is existed out of, or entered into

"connect [noreply] [write] fence clear {name}" - delete a specified fence

"connect [noreply] [write] fence clearall" - remove all fences from the unit

"connect [noreply] fence resettimeout" - reset fence breach notification timeout

-------------

[] = an optional keyword that may or may not be included in the message

The "noreply" keyword possible on certain commands as shown above suppresses "OK" confirmation messages sent from the device after receipt of e.g. a "fence set" command message (note it does not suppress "ERROR" messages).

The "write" keyword possible on "fence" commands only causes changes to be saved immediately, its use is not recommended.  By default all "fence" commands are saved after a 5 minute timeout (from the issuing of the last command) to minimise the amount of erase / write cycles performed to internal memory.  It is recommended that "fence" command messages should be done in groups with a gap of no-longer than 5 minutes between them, and should not be done unnecessarily.  "unit" commands are saved immediately as they are only likely to be changed infrequently.

Unit / fence names, and passwords can consist of a-z, A-Z, 0-9 only without spaces to a maximum of 8 characters.

A maximum of 1 fence breach SMS will be sent per hour.  If you wish to reset the 1hr timeout this can be done via the "resettimeout" command.